fuse box RENAULT TWINGO RS 2009 2.G Electrical Equipment - Airbags And Pretensioners Workshop Manual

88C-23
MR-413-X44-88C000$616.mif
V3
AIRBAGS AND PRETENSIONERS
Fault finding - Interpretation of faults
MRSZ AIRBAG
Vdiag: 04
88C
DF002
PRESENT
COMPUTER SUPPLY VOLTAGE
1.DEF: Supply voltage too high
2.DEF: Supply voltage too low
NOTESUse the Wiring Diagrams Technical Note, New TWINGO.
Check the condition of the airbag computer connector component code 756 (see Wiring Diagram Technical
Note, New Twingo, Component code 756 and Technical Note 6015A, Repairing electrical wiring, Wiring:
Precautions for repair).
If the connector is faulty and there is a repair method (see Technical Note 6015A, Repairing electrical wiring,
Wiring: Precautions for repair), repair the connector, otherwise replace the wiring.
Check fuse F7 15 A on the passenger compartment fuse box, component code 1016.
With the ignition on, check for + 12 V on connection AP25 of the airbag computer, component code 756:
10.5 V ± 0.1 < voltage OK < 16 V ± 0.1.
If there is a repair method (see Technical Note 6015A, Repairing electrical wiring, Wiring: Precautions for
repair), repair the wiring, otherwise replace it.
–Check the battery charge.
–Check the charge circuit (see 80A, Battery).
–Check the tightness and the condition of the battery terminals.
–Check the computer earth connection NAP.
Use the universal bornier to check the insulation and continuity of the following connections:
–Connection code AP25 between components 756 and 1016,
–Connection code NAP on component 756.
If there is a repair method (see Technical Note 6015A, Repairing electrical wiring, Wiring: Precautions for
repair), repair the wiring, otherwise replace it.
If the fault is still present, contact the Techline.
AFTER REPAIRClear the computer fault memory. Switch off the ignition.
Carry out the check again using the diagnostic tool and, if there is no fault, unlock the
computer.
ABGMRSZ_V04_DF002P

88C-66
MR-413-X44-88C000$924.mif
V3
88C
AIRBAGS AND PRETENSIONERS
Fault finding - Fault Finding Chart
ALP 1 No communication with the airbag computer
NOTESSpecial note:
See "Introduction" for the + after ignition feed to perform fault finding on a
computer.
Use the W iring Diagrams Technical Note, New TWINGO.
Try to establish dialogue with a computer on another vehicle to make sure that the diagnostic tool is not faulty. If
the tool is not the cause and communication cannot be established with any other computer on the same vehicle,
it is possible that another computer is disrupting the multiplex network.
Proceed by successive disconnections to locate the defective computer. Check the battery voltage and perform
the necessary operations to reach the correct voltage.
(10.5 V < battery voltage < 16 V).
Check for the presence and condition of the supply fuse (F7 15A) of the airbag computer component code 756
on the passenger compartment fuse box component code 1016.
Check the connection of the airbag computer connector, component code 756 and the condition of its
connections.
If the connector is faulty and there is a repair procedure (see Technical Note 6015A, Repairing electrical
wiring, W iring: Precautions for repair), repair the connector, otherwise replace the wiring.
Check that the airbag computer, component code 756, is correctly supplied:
–Check and ensure the presence of + after ignition feed between the terminals marked earth connection
code NAP and + after ignition feed connection code AP25.
If the + after ignition feed is absent:
Check the insulation against earth and the continuity of the following connection:
–Connection code AP25 between components 1016 and 756.
Check the continuity of the following connection:
–Connection code NAP between component 756 and the earth NAP.
If the connection or connections are faulty and there is a repair procedure (see Technical Note 6015A, Repairing
electrical wiring, Wiring: Precautions for repair), repair the wiring, otherwise replace it.
AFTER REPAIRWhen communication is established, deal with any faults indicated.
ABGAB9_V04_ALP01
MR-413-X44-88C000$924.mif
MRSZ AIRBAG
Vdiag: 04